Pelican logo

Pelican 1600 Protector Case with Foam Insert

Pelican 1600 Case
$22 delivery

$599.95 $499

IN STOCK NOW

warranty
australian stock
insured delivery

Pelican 1600 Protector Case with Pick 'n' Pluck Foam

  • Watertight, crushproof, and dustproof
  • 2 level Pick N Pluck™ with convoluted lid foam
  • Open cell core with solid wall design - strong, light weight
  • Comfortable rubber over-molded handle
  • Stainless steel hardware and padlock protectors
  • Automatic Pressure Equalization Valve - balances interior pressure, keeps water out
  • O-ring seal

Sensitive equipment needs protection, and since 1976 the answer has been the Pelican™ Protector Case. These cases are designed rugged, and travel the harshest environments on earth. Against the extreme cold of the arctic or the heat of battle, Pelican cases have survived.

Made in the USA, these tough cases are designed with an automatic purge valve, that equalizes air pressure, a watertight silicone O-ring lid, over-molded rubber handles and stainless steel hardware.

Keep your projector safe with a genuine Pelican Hard Case

With the included foam insert, this Pelican 1600 Hard Case can hold projectors with dimensions up to 49.6cm wide x 37cm deep x 17cm high.

The Included Pick'n'Pluck foam allows you to easily customise your case interior to hold projectors and other items of varying shape. A layer of foam is pre-scored in tiny cubes. Simply lay your projector on the foam, tape or chalk to mark the foam, and pluck away. Always allow at least one inch of foam between your items and the wall of the case.


pelican 1600 outdoor
Specifications
Dimensions
Interior 54.6 x 42 x 20.3 cm
Exterior 62 x 49.2 x 22.3 cm
Measurements
Lid Depth 4.4 cm
Bottom Depth 15.5 cm
Total Depth 20 cm
Int Volume 0.047 m
Padlock Hole Diameter 8 mm
Weights
Weight With Foam 6.4 kg
Weight Empty 5.9 kg
Buoyancy 53.1 kg
Materials
Body Material Polypropylene
Latch Material ABS
O-Ring Material Polymer
Pins Material Stainless Steel
Foam Material 1.3 lb Polyurethane
Purge Body Material ABS
Purge Vent Material 3 Micron Hydrophobic Non-Woven
Temperatures
Minimum Temperature -40° F (-40 ° C)
Maximum Temperature 210° F (99 ° C)
Approvals
Certifications IP67   /  MIL C-4150J   /  Def Stan 81-41   /  ATA 300

Found a better deal? Give us a Call!