| Buyers Guide
Projectors
Screens
Accessories
|
| NEC VT49G Digital LCD PROJECTOR |
|
 |
|
 |
For the current NEC Range Click here |
 |
- DVI input connector (DVI-I) and HDCP compatible (VT695 and VT595 only)
- Auto Vertical Keystone Correction (VT695 and VT595 only)
- Very quiet operation
- Quick start & quick cool down
- Wall Colour Correction
- Built-in speaker (5W for VT695 / VT595 and 1W for VT590 / VT490 / VT59 / VT49)
- Security function
| DVI input connector (DVI-I) and HDCP compatible (VT695 and VT595 only) |
| With the DVI-I input connector (DVI-I), the projector can display digital RGB images. By using the DVI-RGB adapter, analogue RGB signals can be connected from two computers. |
| The projector can be set up or put away quickly with the Quick Start and Quick Power Off function |
 |
| Eight seconds after turning on the power, the projector is ready to display PC or video images. Powering down, the fans stop 30 seconds after turning off the power from the remote control or cabinet control panel. The projector can be stored immediately after powering down. The main power for the projector can be turned off by either pressing the main power switch or by unplugging the power cable, even during the cool down period after the projector is turned off. |
|
| Wall Colour Correction enables vivid images even without a screen |
| Without a screen, projected images are affected because of the colour of the wall or blackboard you are projecting on to. The built-in colour correction for projecting images on a coloured wall or blackboard in this projector means that the colour tones of the projected image is approximate to those that are projected on to a white screen. The following eight colour options are available: blackboard, blackboard (gray), light yellow, light green, light blue, sky blue, light rose, and pink. |
 |
|
| Auto Vertical Keystone Correction adjusts the trapezoidal distortion to correct the projected image(VT695 and VT595 only) |
| If the position of the screen is too high or low, the projector must be installed at an angle, resulting in trapezoidal distortion of the projected images. The acceleration sensor built into the main unit senses the inclination of the unit in the vertical direction and then corrects for any trapezoidal distortion in the
projected image automatically to project square images (+/- 30 degrees from the projection angle). Projector setup is quick and easy as manual correction is not necessary. Manual vertical Keystone Correction is available on the VT590/VT490/VT59/VT49. |
 |
|
| Eco Mode lowers noise and extends lamp life |
| Eco Mode operation drops projector noise to 25 dB for very quiet operation (VT59/VT49) and extends the lamp replacement period up to a maximum of 4000 hours (VT59/VT49). In this mode, total cost of ownership can be effectively reduced. The projector can be put in to Eco Mode very easily with a button on the remote control. |
 |
| Auto start |
| Turns the projector on automatically when the power cable is inserted into an active power outlet. This eliminates the need to use the POWER button on the remote control or projector cabinet. *To use Auto Start, first set the main power switch to "On" before plugging in the power cable. |
| Built-in speaker for integrated audio solutions |
| The built-in monaural speaker (5W for VT695/VT595 and 1W for VT590/VT490/VT59/VT49) on the main unit outputs audio from computer, video, and S-video inputs. |
| Carrying handle for easy transport |
| The supplied carrying handle can be installed on the main unit for easy transportation. (VT695/VT595/VT590/VT490 only) |
|
| Security function prevents unauthorized use or theft |
| By using passwords, the projector cannot be used by unauthorized persons. Once the Security function is in effect, a message requesting the password is displayed when the power of the main unit is turned on. It is impossible to project an image unless the proper password is entered. |
|
|
Specifications
| Model Name |
|
VT695 |
VT595 |
VT590 |
VT490 |
VT59 |
VT49 |
| LCD Panel*1 |
|
0.63inches p-Si TFT
active-matrix with MLA |
0.6inches p-Si TFT active-matrix with MLA |
| Resolution |
|
XGA (1024 x 768) |
SVGA (800 x 600) |
XGA (1024 x 768) |
SVGA (800 x 600) |
| Lens |
Manual Focus |
(Range 1.5 to 1.8)(f=18.9mm to 22.7mm) |
(Range 1.8)(f=22.4mm) |
| Zoom |
Manual (Ratio:1.2) |
Digital (Ratio:1.2) |
| Lamp |
Normal Mode |
200W DC |
190W DC |
150W DC |
| Eco Mode |
150W |
120W |
| Lamp Life |
Normal Mode |
2000H |
3000H |
| |
Eco Mode |
3000H |
4000H |
| Light Output |
|
2500 ANSI lumens
(Approx.75% in Eco Mode) |
2000 ANSI lumens
(Approx.80% in Eco Mode) |
1600 ANSI lumens
(Approx.80% in Eco Mode) |
| Contrast Ratio (White/Black) |
|
600 : 1 |
| Fan Noise |
Normal Mode |
35dB |
34dB |
32dB |
| Eco Mode |
29dB |
25dB |
| Image Size |
|
21 to 300 inches |
25 to 300 inches |
| Projection Distance |
|
0.7m to 10.7m |
0.7m to 11.1m |
0.9m to 11.0m |
| Projection Angle |
|
8.3° to 8.6° (Tele) , 9.9° to 10.3° (Wide) |
8.4° to 8.7° |
| Colour Reproduction |
|
Full Colour, 16.77Million Colours Simultaneously |
| Maximum Resolution |
|
UXGA (1600 x 1200) |
| Keystone Correction Vertical |
|
Manual/Automatic ±30degrees |
Manual ±30degrees |
| Scan Rate |
Horizontal |
15kHz to 100kHz (RGB : 24kHz or over) |
| Vertical |
50Hz to 120Hz |
| Input Signal Bandwidth |
|
RGB : 80MHz/Video : 6.5MHz |
| Input Terminals |
Computer Input |
2 VGA |
1 VGA |
DVI-I 29pin
(Computer 2) |
DVI digital (with HDCP) |
- |
Component Input
(Sharing with
Computer 1
Input) |
1080i,720p,480p,480i/60Hz 1080i,576p,576i/50Hz |
| Composite |
NTSC/NTSC4.43/PAL/PAL-N/PAL-M/PAL-60/SECAM |
| S-video |
Mini DIN-4pin 1.0Vp-p/75O(With Sync) |
| Output Terminals |
Computer Output |
D-Sub Mini 15pin Only Computer1 can be output |
| Control Terminals |
|
Mini DIN-8pin RS-232C |
| Built-In Speaker |
|
5W Monaural |
1W Monaural |
| Environment |
Operational Temperatures |
5°C to 40°C, 20% to 80% Humidity (Non-Condensing) Eco mode selected automatically at 35°C to 40°C |
| Storage Temperatures |
-10°C to 50°C, 20% to 80% Humidity (Non-Condensing) |
| Power Consumption |
Normal Mode |
285W |
270W |
255W |
205W |
| Eco Mode |
220W |
205W |
170W |
| Standby Mode |
9W |
| Input Current |
|
3.1/1.3A(100/240V AC) |
2.4/1.0A(100/240V AC) |
| Power Requirement |
|
100 to 240V AC, 50Hz/60Hz |
| Net Weight |
|
3.0kg |
2.9kg |
2.8kg |
| Dimensions (WxHxD) |
|
309mm x 112mm x 258mm (Not Including Protrusions) |
| *1 : |
LCD Panel technology consists of fine picture cells with more than 99.99% of the cells being active. |
| *2 : |
Lamp life is defined as the average time span for the brightness of the lamp to be reduced by half, it dose not refer to the warranty period for the lamp.
All specifications are subject to change without notice. |
Supplied Accessories
|
Carry Bag |
Remote |
|
|
|
|
| Optional Accessories |
|
|
|
|
Extended Warranty
|
Program Coverage:
- LCD & DMD pixels are covered only as per original manufacturer's pixel terms & conditions
- Does not cover Cords, Power Adapter
- Does not cover consumable items such as projector globes |
| + 3 Year On-Site Extended Warranty (up to 5 years total) |
$149 |
| + 2 Year On-Site Extended Warranty |
$119 |
| + 1 Year On-Site Extended Warranty |
$99 |
|
|
|
Viewsonic WPG-350 Wireless Presentation Gateway |
Pick Up Avail.
|
- Upgrade any Projector To Wireless
- Fully compatible with both Windows and Mac® OS
- Supports resolutions up to 1024x768 and full-motion
video up to 1080p
- Presentation remote for total conference control
- Equipped with VGA pass-through for an extra display |
|
|
|
Premium VGA Monitor Cable (15HDM/15HDM) |
Aus Wide Delivery: $15
|
Heavily shielded coaxial RGB cable giving you a crisper display at higher resolutions!
| . |
Features UL Approved Cabling |
| . |
Filters included on both ends cutting down on noise |
| . |
Maintains stronger signals using a shielded cabling run. |
| . |
Comes in 15pin D-sub format with Male to Male conectors |
| |
|
|
| Buy your new VT49G projector now, Contact Us today! |
|
|
|
